BQNYM - KEL-SEAL TERPOLYMER COATING 1128 SERIES

  • MSDS: BQNYM
  • Manufacturer: KELLY MOORE PAINT CO INC
  • Product Name: KEL-SEAL TERPOLYMER COATING 1128 SERIES
  • National Stock Number: 8010-00N011996
Product Identification

Product ID:KEL-SEAL TERPOLYMER COATING 1128 SERIES
MSDS Date:05/03/1990
FSC:8010
NIIN:00N011996
MSDS Number: BQNYM

Responsible Party
KELLY-MOORE PAINT CO,INC
1015 COMMERCIAL ST
SAN CARLOS, CA 94070
US

Emergency Phone: 800-424-9300 (CHEMTREC)

Info Phone: 415-592-8337

Preparer: JULIAN E SCHAFER

Cage: 23865

Contractor
KELLY-MOORE PAINT CO INC
SAN CARLOS, CA 94070 US

Telephone: 415-592-8337

Cage: 23865

Ingredients

0.1 MMHG.

CAS: 107-21-1

RTECS: KW2975000

Fraction By Weight: <5%

OSHA PEL 50 PPM C

ACGIH TLV: 50 PPM C VAP & MIST

EPA Report Quantity: 1 LB

DOT Report Quantity: 1 LB


PHENYLMERCURIC ACETATE.PAINT PRESERVATIVE TO CONTROL

CAS: 62-38-4

RTECS: OV6475000

OSHA PEL 0.1 MG(HG)/M3 SKIN

ACGIH TLV: 0.1 MG(HG)/M3 SKIN

EPA Report Quantity: 100 LBS

DOT Report Quantity: 100 LBS

Hazards

LD50 LC50 Mixture:N/K
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:CHRONIC:NONE KNOWN.
Explanation of Carcinogenicity:NONE
Effects of Overexposure:EYES/SKIN:IRRITATION.INGESTION:NAUSEA,
DIZZINESS,HEADACHE,CONFUSION,UNCONSCIOUSNESS.INHALATION:NAUSEA,DIZZ
INESS, HEADACHE,CONFUSION,IRRITATION TO UPPER RESPIRATORY
TRACT,UNCONSCIOUSNESS.
Medical Cond Aggravated by Exposure:SEE YOUR PHYSICIAN FOR SPECIFIC
MEDICAL OPINION REGARDING YOUR CONDITION.

First Aid

First Aid:EYES:FLUSH WITH LARGE VOLUMES OF WATER FOR AT LEAST 15
MINUTES.GET MEDICAL ATTENTION.SKIN:WIPE OFF WITH A RAG.WASH
THOROUGHLY WITH SOAP AND WATER.INGESTION:CONSULT HOSPITAL EMERGENCY
ROOM OR POISON CO NTROL CENTER IMMEDIATELY.INHALATION:REMOVE TO
FRESH AIR.RESTORE BREATHING.CONSULT PHYSICIAN.

Fire Fighting

Flash Point:>200F,93.33C
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED SCBA AND FULL
PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:CLSD CONTR MAY EXPLODE (DUE TO BUILDUP OF
STEAM PRESS) WHEN EXPOSED TO EXTREME HEAT.HAZ DECOMP PROD:MAY
PRODUCE HAZ FUMES WHEN HEATED TO DECOMP AS IN WELDING.

Accidental Release

Spill Release Procedures:VENTILATE AREA TO PREVENT BUILD-UP OF
VAPORS.FOR SMALL SPILLS,SOAK UP WITH ABSORBENT.FOR LARGER
SPILLS,DIKE AREA WITH ABSORBENT MATERIAL AND SCOOP UP LIQUIDS.
Neutralizing Agent:N/K

Handling

Handling and Storage Precautions:STORE UPRIGHT IN SEALED CONTAINERS
AWAY FROM HEAT AND FLAME.
Other Precautions:REMOVE AND WASH CONTAMINATED CLOTHING BEFORE REUSE.

Exposure Controls

Respiratory Protection:USE PARTICLE MASK TO AVOID BREATHING SPRAY MIST/
SANDING DUST IF LOCAL VENT IS ADEQUATE TO KEEP TLV WITHIN
ACCEPTABLE LIMITS.IF LOCAL VENT IS NOT ADEQUATE,THE USE OF AN
APPRVD RESPIRATOR FOR ORGANIC V APOR,SUPPLIED AIR/SCBA IS
RECOMMENDED.
Ventilation:LOCAL EXHAUST SUFFICIENT TO KEEP TLV BELOW PRESCRIBED
LIMITS.
Protective Gloves:REC IF NEC TO PVNT EXTENDED EXPOSURE.
Eye Protection:GLASSES W/ SIDE SHIELDS/GOGG (SEE SUP)
Other Protective Equipment:N/K
Work Hygienic Practices:REMOVE AND WASH CONTAMINATED CLOTHING BEFORE
REUSE.
Supplemental Safety and Health
PRODUCT CONTAINS PIGMENTS (TITANIUM DIOXIDE, SILICATES,SILICON DIOXIDE)
THAT MAY BE DUST HAZARDS IN THEIR ORIGINAL DRY POWDER FORM BUT ARE
NOT HAZARDOUS IN WET PAINT.BP:212F,(H2O)100C.SPEC GRAV:1.08-1
.32,H2O=1.RTE OF ENTRY:SKIN/EYE CONTACT(MFR).EYE PROT:ARE REC TO
PVNT EYE CONTACT.

Chemical Properties

HCC:N1
Boiling Pt:B.P. Text:SEE SUPP
Melt/Freeze Pt:M.P/F.P Text:N/K
Decomp Temp:Decomp Text:N/K
Vapor Pres:N/K
Vapor Density:<1 (AIR=1)
Spec Gravity:SEE SUPP
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:N/K
Appearance and Odor:N/K
Percent Volatiles by Volume:45-55

Stability

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS.
Hazardous Decomposition Products:MAY PRODUCE HAZARDOUS FUMES WHEN
HEATED TO DECOMPOSITION AS IN WELDING.

Disposal

Waste Disposal Methods:DISPOSAL MUST BE IN ACCORDANCE WITH
FEDERAL,STATE AND LOCAL REGULATIONS .DISCARD IN LAND FILL IN SEALED
METAL CONTAINERS AWAY FROM HEAT AND FLAME IN ACCORDANCE WITH
REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.